Packard Forum Index » Project Blogs

I made these back in the 90s, from molds my dad made,,used durathane,


I use the 55 on the bottom, with or without cup.

Attach file:

---

  (9.90 KB)

Very nice,

I sent some NOS to Lynn Steel when the Packard National was in Ashville.

thanks,

if your in need,, let me know,

rik

but better wait to see how these work!!!

one of these days I am going to make more. back when I made these it was 80 bucks a can,,,i am sure it went up!

had to buy thru grainger.

all the rubber ones I've used gave up in about a year,,the bottom ones...

maybe to much up and down,,showing people how it works.

thanks again,,

rik

A few before and after pictures of my rear support arm bushings.

Attach file:

---

  (129.96 KB)


  (137.41 KB)


  (108.96 KB)

hope the new ones are holding up,,