Packard Forum Index » V-8 (1955-56)

It is very possible the generator overheating is due to the Torsion Level not working properly. In cases like this when two problems crop up at the same time, they are often related. It could be a wire or wires on the Torsion Level system are shorted together or against the frame, possibly by being chewed by mice after sitting for a long while, or a solenoid has stuck in closed position... The fuse in the torsion level system cannot always be relied on to 'open'...or it may be bypassed..... The way I troubleshoot a problem like this is to first disconnect all power sources to the torsion level system....and observes what the generator then does.... Wiring to the generator is also suspect in the same manner that the torsion level wiring would be suspect....shorted wire to frame, wire shorted to another wire, etc.

Not meaning to deflect this thread, but you might want to join the Packard club, which should help you find qualified help in your area.

Get to know the Packard people in your area; they can point you to specialist mechanics and local vendors--as well as who to avoid....

I took your advice and joined the Packard Club. Thanks for the suggestion