Packard Forum Index » Project Blogs

This will work.

The start of insulator. ...
.
NY sample.. Have 2 feet of round plastic.

Clear coat should bring out shinny black

Attach file:

---

  20220714_201924.jpg (6,127.99 KB)

280 bucks.

And i need to redo these.

The lining was to thick.

They arced them . and left less than a 1/16th before rivets hit.

I countersunk them. Know i have wear.

Front ate done.

Rear are ready to be countersunk.

Attach file:

---

  20220725_173515.jpg (5,429.74 KB)


  20220725_182417.jpg (5,426.24 KB)


  20220725_182428.jpg (4,814.51 KB)

How I spent 67.

Finally stopped the nagging squeak.

The driver side stabilizer up top was stuck. (Rubber).

All now have polyurethane.

And had to use jacks to get it all lined up

And new shocks . Gabrielle. .

Attach file:

---

  20220805_165327.jpg (6,722.24 KB)


  20220805_165341.jpg (5,230.77 KB)


  20220805_165353.jpg (4,913.20 KB)


  20220805_194800_(1).jpg (715.08 KB)


  20220805_195256.jpg (6,979.75 KB)


  20220805_195318.jpg (6,679.76 KB)

My squeak is back.

So. Need to redo the stabilizer.

Think I have it to tight. And the top link is binding.

Alright

So changed set up.

Put spacer on. No squeak . drove it.

Got home squeak.

So my take is. Bushings are to tight.

One picture is my dads.

Other is mine. So that bolt. The non threaded part is 1-3/4.

So I was going to leave it. Out I threaded it down to 1-1/2.

Which I think is too tight. Well its has to be. They are squeaking.

Also my dads does not have these large washers.

At first. It was real free. Its would go up and down. Spring back.

But a washer between plates. And that gave me a gap. Both sides.

But. It needs more..

So got to pull it and modify it.

But going to use a Vernier and measure my dads .

Now its tight again.

Attach file:

---

  20220808_175237.jpg (8,113.60 KB)


  20220808_134017.jpg (8,308.53 KB)

So I have bushings to tight.

They rotate around pin.

So will need maybe 1/4 inch spacers.

Attach file:

---

  20220812_134147.jpg (5,822.21 KB)