Packard Forum Index » Pre-War (1899-1942)

On my Packard 1933, model 1001, the camshaft gear and the engine oil pump drive gear are worn.
I also noticed that the oil pump shaft driving gear bearing (Part Nr. 170082) is ground down, which may be causing the gears to be in the wrong position relative to each other.
Can anyone tell me the original dimensions of the bearing.
Thanks in advance.

Josef

I have a used 1001 oil pump in my parts bin. If I can take any measurements from it that would be useful to you, please advise in detail.

Thank you for your answer.
Maybe the part is also called "Motor oil pump driving shaft bushing".
I come from Austria and am not so familiar with the English terms.
In the attached pictures I have marked the dimensions that would be interesting for me to be able to remake the bushing.

Josef

Attach file:

---

Motor oil pump driving gear.pdf Size: 1,507.22 KB; Hits: 150
Motor oil pump driving gear.pdf Size: 1,507.22 KB; Hits: 72