Packard Forum Index » V-8 (1955-56)

I am looking for a rear fender molding, drivers side, the middle one. It starts at the lower part of the courtesy light and extends to the tail light where it flairs to a point.
I have tried the usual places like Kanter and Merrit with no luck. Any suggestions or ideas where to look?
Thanks

Care to provide a part number? I do believe I have it and I think it's NOS. I was keeping it as a "just in case" part along with most all the other external trim but might be willing to part with it. I'll be away for 10 days starting tomorrow so may not be able to check on it until I return.

"I'll be away for 10 days starting tomorrow"

Dave, enjoy going North to Alaska!

Thanks Mal. It's been 14 years since I was last there and wanted to get back one more time, and this more into the inland. On all these trips I try to make contact with local Packard folk and I've got a Packard friend who lives not too far from Denali and I'm going to try to make contact with him.

Hi Dave,
As Mal said have a good trip to Alaska and watch out for the grizzly bears.
Take care
Terry