Packard Forum Index » Post-War (1946-54)

Hi, I'm looking for a good pictorial of the Clutch Linkage for a 47 with the Electromatic Clutch hook up. I saw the one in the parts book, but I could use a good break down of the parts. Mine is in bad shape see picture below.
Thanks!
Wes

Attach file:

---

  (36.19 KB)

Here's a few. If you need something more specific I'll try and get it. Without taking it apart, IIRC that bolt the arrow points to has a shoulder which the slot in the link slides over. A washer the diameter of the shoulder goes on each side of the link. The bolt threads into the relay lever up to the shoulder and then a nut double locks it.

Attach file:

---

  (81.74 KB)


  (103.53 KB)


  (114.60 KB)


  (108.70 KB)


  (119.18 KB)

Thanks Howard, from looking at the parts book I could see the outside washer, but not the inside one. So thanks for the heads up on that. It looks like I need to make a new bolt, mine doesn't have enough shoulder on it and I was thinking about a castle nut with a cotter key, but the double nut would be easier.
As always thanks for the help.
Wes