Packard Forum Index » V-8 (1955-56)

I'm trying to remove the universal joint flange from the rear housing of a 55 Ultramatic in order to replace the seal and bearing. The problem is the removal of the flange retainer. It doesn't just come off. I have tried an expanding fastener inserted in the retainer, expanded and then pulled on and inserting a rod down the output shaft against the retainer to try and push the retainer. Neither has been successful. Any suggestions would appreciated.

Thread the retainer. Screw in a bolt. Use a rod to poke it out from the shaft end.

Thanks Ross, that worked very nicely.