Packard Forum Index » Project Blogs

So I decided to add turn signals to my survivor but temporary ones that I can take off easily and not actually "update" the car itself. I might fine tune how these attach after some test drives. This is a combo of some tail lights, wireless bike lights, velcro strap and rubber 3m backing. The lights were roughly $100 all in but you could do a little cheaper (I bought the 4-light bike set in case I needed to tear down the lights to install). The one pic is the remote signal with the bike light that I embedded in the housing. The back you can see the charging cable with a cap so I can recharge without taking these apart. The light itself also has an extra square flasher (looks like a red button) that can be used in conjunction with the signal or as a hazard.

Attach file:

---

  PXL_20230303_020719027.jpg (21.59 KB)


  PXL_20230303_020722326.jpg (26.51 KB)


  PXL_20230303_020732232.jpg (27.94 KB)


  PXL_20230303_022133831.jpg (22.10 KB)