Re: Shifter Stop Improvement for 54-56 Twin Ultramatics
|
||||
---|---|---|---|---|
Home away from home
|
1/8 inch? Flat.
Nice to have a backup. With the shift motor not a problem finding R. Keep it in R while fitting the piece..
Posted on: 7/4 22:41
|
|||
Riki
|
||||
|
Re: Shifter Stop Improvement for 54-56 Twin Ultramatics
|
||||
---|---|---|---|---|
Home away from home
|
Just for reference in the dimension department:
The piece is made from 1" wide steel. The angle is bent about ¾" from the front side of the transmission, as shown. The total height is about ⅝". It is intended that you adjust the angle to adjust the stop location. The factory transmission bolt is sufficient for re-install. The piece should have a countersink on the side opposite the bolt head, to reduce possible movement.
Posted on: 7/4 22:42
|
|||
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog 1955 Clipper Super Panama | Registry Email (Parts/service inquiries only, please. Post all questions on the forum.) service@ultramatic.info |
||||
|