well gave it a good scrub. pulled the carpet and under pad out, sprayed Febreze and the natures own pet odor spray(forget the name)

cleaned out all the valuables from the trunk:)

what is the cover supposed to look like that covers the hole in the floor? some rust, but not all the way thru thankfully. will a good wire brushing and some paint work to seal it up?

got heat in my garage now, now just need to get the car in there for the winter. will remove the fuel tank before I bring the car in( if the wife approves that the the smell is not so offensive.) and get it cleaned. better so do now than have a bunch a fumes in the garage.

Attach file:

---

  (341.29 KB)


  (310.34 KB)


  (363.43 KB)


  (230.42 KB)

I will look for that . Thank you!

Thanks all of you for the advice, very much

Thanks Mal for turning the photos.......couldn't figure that out

Thus begins my attempt at restoring my Fathers car into a driver. First thing is to get rid of all the mouse poo, nests,and especially the stink. Washed the outside to get rid of all the bat poop. Never restored a car before, think after the deep clean I will work on getting it running, fixing the brake system, then go from there

Attach file:

---

  (209.42 KB)


  (251.00 KB)

Thank you so much HH56!

Any source suggestions for the hand rivet setting tool?

Will try that, again thank you very much!

Thanks for the education! I tested both units, then cleaned the points and tested them again. 1 unit works perfectly, 7-8 seconds, both sides. The second unit.....1 side seems good, 7 seconds, the other side takes upwards of 25-30 seconds. I assume that means there is an issue with the 2nd unit? or can the points in location 2 be adjusted?

Wow! Awesome! Thank you very much! I will give this a go

Sean