Henry, just went out in the garage and looked at the radiator mounting. The cradle on my Clipper has four holes (2 on each side) tapped for 1/4" coarse thread. I cut short lengths of 5/16" fuel line tubing. Length was determined to have the two toilet tank washers being slightly compressed when the bolt is tight. Don't remember the specific tank washers I bought at Lowe's, but they are a common item. I'll look at my project blog and see if anything more comes to light.
(o{}o)
Looked at the project blog, but nothing new popped out.
Here is the link
https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?topic_id=7272&viewmode=flat&order=ASC&type=&mode=0&start=40 Please note I did not bother with the cradle mounting to the frame, so can't comment on that part.
The NOS lower stainless trim looks great. Glad it went to you.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=154027