Craig, With the dpdt switch is there any way to move the car up and down level at the same time? Or is it possible to move the rear down and then the front down without raising the rear back up?

Hi all, the 7 second delay on my torsion ride is not working. the moment the car is out of adjustment it clicks in. Is there any way to fix these delay timers or is it just buy a new one and is there any other options other than the expensive packard ones.

Thanks
bill

You guys are hilarious...being 32 I had no idea.

I am not familiar with dagmars. Are those the bullets? I have a lead on a 56 grill and according to Ross that should bolt right in. But I am still not understanding the turn signal issue. Are they in the wrap around pieces on a 56?

What is the difference with the lights?

Hi all, So long story short. I picked up front bumper a few years ago to fit on my 55 clipper and come to find out it is a 56 bumper. And apparently they do not fit with a 55 grill (bumper bullets are closer to center). So my question is, will a 56 grill with a 56 bumper fit my clipper? I'm not worried about originality. I know the 56 has the those pieces that wrap around the front fender but I think those are separate pieces.

Thanks guys

The piece in the front nose of the housing, is that a seal or a bearing? Did you replace that too?

Thanks
Bill

Yes, that's perfect, now I just need to find them....

thank you

Bill

Hi all. I am piecing back together my interior and I am not sure what the chrome window trim on the inside of the car goes into. Can someone take a picture of theirs for me. Above the vent window on the headliner the chrome trim stops and there is nothing until the windshield post.... what goes there? Also it is a 2 Dr car.


Thanks so much Bill.

Yes, sorry it is for the cap of where the oil filter goes. I did not get one in the box when I received it.