replacement wheel for 41 120
|
||||
---|---|---|---|---|
Just can't stay away
|
Is there a modern replacement for a 1941 120 wheel?
Posted on: 2020/12/2 14:40
|
|||
|
1941 120 wheels
|
||||
---|---|---|---|---|
Just can't stay away
|
Is there a modern replacement for the wheels on a 1941 120?
I have a one where part of the outer rim has rusted away and looking for a replacement. Thanks, Casey Rog
Posted on: 2020/7/2 15:22
|
|||
|
Re: 12 volts for 6 volt horns
|
||||
---|---|---|---|---|
Just can't stay away
|
Thanks, for the response, I'll clean up the contacts
Posted on: 2019/11/1 14:58
|
|||
|
12 volts for 6 volt horns
|
||||
---|---|---|---|---|
Just can't stay away
|
I am having a problem with the horns on my41 120. I am running on 6 volts and the horns sound fine when I run the car and ground the wire that is supposed to go to the steering wheel horn button. When I try the steering wheel horn button the sound is weak as if I am not making good contact at the horn button. All the wires are of the proper diameter and new. My question is can I run the horns on 12 volts without any damage. I start the car on 12 volts with the battery under the front seat and run the car on 6 volts with the battery under the hood.
Thanks in advance for any help.
Posted on: 2019/10/26 10:10
|
|||
|
Re: piston slap
|
||||
---|---|---|---|---|
Just can't stay away
|
Thanks for the information
Posted on: 2019/4/18 17:33
|
|||
|
piston slap
|
||||
---|---|---|---|---|
Just can't stay away
|
My 41 120 has piston slap in #4 cylinder. Short of re-boring the cylinder, is there another solution. After the engine warms up the noise disappears. Please advise, and what is a piston skirt expander?
Posted on: 2019/4/17 16:16
|
|||
|
1941 120 air cleaner element
|
||||
---|---|---|---|---|
Just can't stay away
|
Can someone please advise me of a paper air cleaner I can use to replace the oil bath air cleaner on my 1941 120, model 1901?
Thanks in advance Casey Rog
Posted on: 2018/11/14 17:50
|
|||
|
1941 120 rocker panels
|
||||
---|---|---|---|---|
Just can't stay away
|
Does anyone know of a source for replacement rocker panels for a 1941 120? I bought the right side from classic 2 current and it was not the correct profile, but I did cut it up and use it for the rear lip on the trunk floor.
Please advise is anyone has a source for the correct rocker panels. Thanks, Casey Rog
Posted on: 2017/7/18 14:41
|
|||
|
brake backer plate removel 1941 120
|
||||
---|---|---|---|---|
Just can't stay away
|
I am replacing the grease seals on the rear axel on my 1941 120. I did the passenger side and had a heck of a time putting the emergency brake cable back in place. Is it possible to remove the axle without removing the brake backer plate? I can clamp it in place while I remove the old hardware and grease seals. Has anyone done this before?
Thanks in advance.
Posted on: 2017/5/30 14:01
|
|||
|