V 8..

Have not got car on road yet..close...too windy today to add oil..

Next week hope to be the road.

I have firm pedal..have not bleed system yet...

Ross rebuild...full faith in Ross..

Ugh..

After trans install.. Shift motor went to park..

Went to take out of park..to tighten drive shaft nuts.

Pushed P...didn't go into park.

After going thru tests..didn't have power with l.h.d.

Went under touched motor went into R. So dropped pan..for some reason shift motor needed to be pulled out..so bent strap..everything works now..thinking about replacing motor strap with 1/16 or 1/8 inch flat hot roll.

Something must get grounded..but you can get cover off without moving trans over..I was thinking of putting insulation on on plate..when trans was out..

Ross.

Is getting my ed strain rebuild..that tv. I would lose pedal..

The tv..I rebuilt Ross found nothing wrong..I had hard pedal..but had to keep pushing on pedal at a stop. Not your normal push..

The rubber. Need to drill 1/2 inch hole.. Still snug fit on shaft..and you need to tighten with outside washer turned backwards..till you get threads for nut

Attach file:

---

  (171.64 KB)


  (251.47 KB)

This area. Next to parking brake

Attach file:

---

  (209.23 KB)

Gerry.

Pac sw...have them....

Ross's mod. To up, the up shift. In hold ing ....end piece took flight..

Washer ..nut..washer..3/16ths.. Goes in side valve...followed by spring..

# 10 nut and washer..

Attach file:

---

  (159.70 KB)

Thanks

H...

Gerry

Pac sw will have everything you need.. Radiator..dist. Gas tank.

Other parts.

https://www.youtube.com/watch?v=mWErjXO3SYg&sns=em


https://youtu.be/n71uznRJeu0