https://www.facebook.com/riki.henneberg/posts/996707687021861

hope you can see it, 56 running

ok, IT RUNS,,,,,,,,

looks like it didn't have an idle,, that i guess was the problem,, i have by passed the ballast, using mallory coil that does not need resistor,

i did change the condenser , to an old one i had, green wire is off starter,,,,

but it has to be the idle screw was down, using used lifters, they did start to clack, bottle P L ,,they went quiet,

oil pressure, needle left of center dot, i did video it, sounds great,,,,straight pipe.........ran for over an hour... high idle, they said 2500 rpm,

thanks everyone.............on to the trans now.....

ps when it started i kept my foot on acc,,it ran,,,,let off,, it quit..........will know tomorrow, i will put it back stock..

ok,,

thanks v8

anyway no luck,, on running, changed points, ran 12v to coil.. fires stops

a few years ago, i tried to buy one, and you had be be a lock smith,

a lock smith showed me the law, , it protects their job, for sure,

od, not in ca,

thanks v 8,

i think now ,, my problem is the points, so going to change them out,

thanks, yes i have broke that tab, i have an nos switch that came with bezel, the switch came from my dads friend, who passed on.

hh, thanks,

i have a used ign, switch , with tumbler in it, and don't have a key for it,

you can't buy buy lock smith tool unless you have a lic. now a days.

hh,

page 20, of electrical, tells what to check,,i was looking for how to remove key tumbler from ign switch