Speedo Cable 43 Clipper
|
||||
---|---|---|---|---|
Home away from home
|
Looking for suggestions on how to diagnose my inoperative speedometer. My 53 speedometer worded when I got it. Upgraded the transmission to OD. Speedometer worked a short while. I had another cable that came with OD transmission so changed it out. Not sure which cable is in the car now and if there is a difference between the two cables. What thoughts do you have as dad as trouble shooting this small problem?
Thanks
Posted on: 2020/10/18 10:35
|
|||
Even the most difficult situations can be learning situations.
1953 Packard Clipper 1957 Chevrolet BelAir 2004 Chevrolet Corvette |
||||
|
Rear trunk Packard Clipper trim
|
||||
---|---|---|---|---|
Home away from home
|
How is the Packard Clipper script held onto the rear1953 trunk lid? Speed nuts? Thanks
Posted on: 2020/10/15 20:42
|
|||
Even the most difficult situations can be learning situations.
1953 Packard Clipper 1957 Chevrolet BelAir 2004 Chevrolet Corvette |
||||
|
Front right fender stainless trim for 53 Clipper
|
||||
---|---|---|---|---|
Home away from home
|
Hey,
I have a 53 Clipper. The trim piece at the very front of the car on the right side fender is missing. About a foot long. Anyone have this part? Thanks
Posted on: 2020/10/14 19:43
|
|||
Even the most difficult situations can be learning situations.
1953 Packard Clipper 1957 Chevrolet BelAir 2004 Chevrolet Corvette |
||||
|
Re: Packard gas tank sending unit
|
||||
---|---|---|---|---|
Home away from home
|
I bought a new tank and sender from Kanter. Installed and does not work properly. I am very interested in buying an alternative to the Kanter sender. What is the consensus of the group for a 53 Clipper? Thanks
Posted on: 2020/10/13 20:47
|
|||
Even the most difficult situations can be learning situations.
1953 Packard Clipper 1957 Chevrolet BelAir 2004 Chevrolet Corvette |
||||
|
Re: Fuel Pump Recommendation for 53 Clipper
|
||||
---|---|---|---|---|
Home away from home
|
Thank you sir. Appreciate your wealth of information once again. My Clipper does not have a mechanical fuel pump. It has the airtex installed now. I ordered a replacement from Amazon. Best always
Posted on: 2020/10/13 20:31
|
|||
Even the most difficult situations can be learning situations.
1953 Packard Clipper 1957 Chevrolet BelAir 2004 Chevrolet Corvette |
||||
|
Fuel Pump Recommendation for 53 Clipper
|
||||
---|---|---|---|---|
Home away from home
|
My electric fuel pump appears to have bit the dust. Looking for recommendations please. 53 Clipper still 6 volt positive ground car. Thanks...Steve
Posted on: 2020/10/13 17:47
|
|||
Even the most difficult situations can be learning situations.
1953 Packard Clipper 1957 Chevrolet BelAir 2004 Chevrolet Corvette |
||||
|
Re: Turn Signals 53 Clipper
|
||||
---|---|---|---|---|
Home away from home
|
Thanks for that information. I have the NAPA unit installed now. I didn't know about the resistor being needed to run the dash indicator bulbs. Is there a direct replacement flasher still available?
Posted on: 2020/10/8 15:53
|
|||
Even the most difficult situations can be learning situations.
1953 Packard Clipper 1957 Chevrolet BelAir 2004 Chevrolet Corvette |
||||
|
Floor Mats
|
||||
---|---|---|---|---|
Home away from home
|
New carpet in the car....what floor mat fits? Is this a trial an error venture? Thanks
Posted on: 2020/10/8 15:13
|
|||
Even the most difficult situations can be learning situations.
1953 Packard Clipper 1957 Chevrolet BelAir 2004 Chevrolet Corvette |
||||
|
Re: Turn Signals 53 Clipper
|
||||
---|---|---|---|---|
Home away from home
|
Thanks for all the information. Turned out to be the flasher. When I jumpered the battery lead to the opposite leg of the flasher receptacle, all turn signals lights came on. Battery to middle leg turns on dash signals. Easy enough
Posted on: 2020/10/8 15:10
|
|||
Even the most difficult situations can be learning situations.
1953 Packard Clipper 1957 Chevrolet BelAir 2004 Chevrolet Corvette |
||||
|