Alright guys, now I'm overly confused. If they are listing both plugs for the car then which ones should I use? Is it dependant on the cylinder head numbers or can I just freely choose to use one of them?

After going back and looking the lady was right (to a point), advance lists the short plugs as being correct for the car, they also list the long ones as bieng correct for the car too.
I'm putting the long ones in but wanted to see if I couldn't clear up any confusion on my part.

Just for those curious ones, they were part # Autolite 437

I was talking about the length of the threads. I went back and looked everything up and the lady there was wrong. I'll just return them and get the right ones. Thanks for all your help.

Hey guys, I bought some plugs from advance auto that they said were the right ones for the car. They were the short reach autolites. The ones I pulled out were long reach plugs. I just thought that someone put the wrong plugs in the car but now I start reading that the long ones are right. Can someone please clear up my confusion.
THanks
Bill

Guys, I replaced the drivers front brake hose with an aftermarket one and I noticed the one I took off had a 1 or 2" nipple on the end that went into the wheel cylinder. The one I put on didn't have this and I am having a hard time getting it tight because it is right up against the backing plate. Do you know if the nipple was supposed to be there or did someone put it there to make it easier to tighten?

Guys, I have a 55 clipper resto project. I started the car up and the gauges don't work, however, the red lights on the oil and generator gauge do work. The gas gauge, temp, oil and amp gauge do not move. I checked the fuse box and everything was good. Is there any other obvious spots to check before I pull the gauges out and start checking for bad grounds?
Thanks
Bill

Thanks for the response, unfortunately I cannot afford a $250 headliner, I have the fabric to make my own and was looking to see if anyone had a junk old one to spare me the pain of trying to create one myself. I forgot to mention its a two door.

Guys, I got this car and it has no headliner. I have the bows in place but was wondering if anyone had a premade pattern or a old junk headliner that I can copy the pattern off of. Or any other suggestions would be helpful.
Thanks
bill

Guys,
I need to remove the front and rear trim of the windows of my 55 clipper. How is this done, I know some cars require the complete removal of the windows to get it done and some you just need the tool. Any suggestions?
Thanks