THANKS SO MUCH for the Info.

Just wrote the Blue Print folks and will keep you posted.

If I can determine a radius and dimension then I will share as a reference for all.

Have a GREAT ONE and I will also post in the Registery.
Casel

I have a New Trunk Pan for my 50 Packard.

By looking at Service Manual it appears this is to curve down at the rear.

The current sheet metal appears to roll over and then curves down.

There are also body nuts to mount the filler panel for the rear bumper so I also need to locate holes.

Looked in Parts Plates but can not find part drawing of trunk pan.

Ideal would be a cross-section.

Does anyone have more details or know where I may find them?

THANKS for the Help
Casel