I just discovered your reply. thanks. How do I locate your project blog?

Thanks I will check the manual

In the process of re-assembling the '54 convertible, I had a glass installer come to put the new rubber on the windshield and put the glass back in. I can't see how the trim is installed; neither the molded trim that is continuous with the trim at the belt line or the trim surrounding the sides and upper W/S. Anyone have experience with this , or suggestions?

Thanks for the picture on the oil filter lines. The ultrsmstic is not the gearstart type.

I am trying to figure out how and where to route the tubing from the Ultramatic transmission to the cooler unit, near the water pump, on this 1954 Packard convertible, 359 ci motor. I wasn't involved in the disassembly and the tubes were cut off rather removed intact. Also I am trying to figure the tubing pattern for the oil filter attatchment. Any diagrams or descriptions would be helpful.