Re: Hood Hardware identification 1941 Pre war
|
||||
---|---|---|---|---|
Not too shy to talk
|
Great evening
Yes it is a 110
Posted on: 3/13 20:46
|
|||
|
Re: Hood Hardware identification 1941 Pre war
|
||||
---|---|---|---|---|
Not too shy to talk
|
Also looks like I’m going to need some kind of metal trim piece
Cover everything and make it look finished Please
Posted on: 3/12 18:26
|
|||
|
Hood Hardware identification 1941 Pre war
|
||||
---|---|---|---|---|
Not too shy to talk
|
Good Day Packrds,
I am working on finding the pieces I need to get the hood operational. I Do not have the bracket and rods that run down the middle of the hood. I have 46 1/8 “ inches between the center holes where the brackets get mounted to the front of the hood and the firewall I have both sides of the hoods I have two latches, I have the brackets and hardware that goes from the latch up and I have the rods that go on the outside of the hood
Posted on: 3/12 18:24
|
|||
|
Re: Carburetor linkage troubleshooting 6 cyl
|
||||
---|---|---|---|---|
Not too shy to talk
|
Thanks Flackmaster I have a bracket that is very similar. & I believe that will work.
The problem I have is the linkages are different Has anyone come across this before? Is it worth modifying ? or should I focus on getting the exact part? Also, I am still missing the Vertical that goes up to the carburetor
Posted on: 3/12 18:02
|
|||
|
Re: WANTED 1941 six cylinder bell crank for carburetor linkage
|
||||
---|---|---|---|---|
Not too shy to talk
|
Holy moly, almost fell off the Couch
Thank you so much I was just contemplating on fabricating one out of metal And yes, I was looking for some doorhandles and window cranks as well I would gladly donate to the website it has been great to me 954 822. 5773
Posted on: 2/9 19:39
|
|||
|
Re: 1941 120 door handles and winder
|
||||
---|---|---|---|---|
Not too shy to talk
|
Good Day Sir
Are they still available
Posted on: 1/23 21:19
|
|||
|
Re: 1941-1947 Packard Clipper Parts For Sale
|
||||
---|---|---|---|---|
Not too shy to talk
|
Are the parts still available?
Posted on: 1/23 21:08
|
|||
|
WANTED 1941 six cylinder bell crank for carburetor linkage
|
||||
---|---|---|---|---|
Not too shy to talk
|
good day fellow old schoolers
I am looking for the shorter carburetor, linkage that goes from the carburetor down to the bell crank I’m also looking for the bell crank ( that is the piece that clips onto the exhaust manifold It transfers the horizontal linkage that comes from the firewall up to the carburetor linkage)
Posted on: 1/23 21:00
|
|||
|
Re: Carburetor linkage troubleshooting 6 cyl
|
||||
---|---|---|---|---|
Not too shy to talk
|
I just found this picture
After I searched for bell crank It looks like mine THANK YOU
Posted on: 1/20 14:58
|
|||
|