Packard Forum Index » Pre-War (1899-1942)

Good Day Packrds,

I am working on finding the pieces I need to get the hood operational.

I Do not have the bracket and rods that run down the middle of the hood.

I have 46 1/8 “ inches between the center holes where the brackets get mounted to the front of the hood and the firewall



I have both sides of the hoods
I have two latches,
I have the brackets and hardware that goes from the latch up and I have the rods that go on the outside of the hood

Attach file:

---

  image.jpg (3,985.21 KB)

Also looks like I’m going to need some kind of metal trim piece

Cover everything and make it look finished

Please

Attach file:

---

  image.jpg (3,348.93 KB)

It may be shown here

packardinfo.com/xoops/html/modules/parts ... list.php?cat=11&partslist=1935-1941

i will supply the short trim piece after the back of the hood and the ornament. You need the center hood stainless, I definitely do NOT have.
As for the pivot, i think you can remove the ball studs and use your rod with a pin clip? i will look again for the vertical rod....

Have found a friend with the center hood stainless moulding...call me tomorrow...

Attach file:

---

  20240312_192547.jpg (8,633.04 KB)

The trim piece is the actual hinge and of course, there are different ones depending on model. Is yours a 110?

Wow Flackmaster
you are batting a thousand.

Thank you so much


Voicemail, you left me, but then it got erased somehow

Can you please call me or text me so I can lock your number in?

Great evening

Yes it is a 110

I have one from a 120 with the open end having gotten damaged so could easily be cut down to the shorter 110 length. I don't know if the hood ornament holes are the same, though, as the car it was from was a 1901A so had a senior ornament. Surely you can fine one for your car without resorting to cutting a longer one but I would love to know the length of a 110's and the ornament holes' spacing so that I can fix this one for 110 use.