Re: 120C conv. hinge pin removal
|
||||
---|---|---|---|---|
Just can't stay away
![]() ![]() ![]() |
If you can give the pin a solid rap from below to move it a 1/4 inch,it will move out easily as the top of the pin has about a 1/4 inch of serrations on it to make it hold fast.
Posted on: 2020/4/27 14:58
|
|||
|
Re: 120C conv. hinge pin removal
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
I got mine out quite easily, I had experienced these darn things restoring my nephew's Model A. After trying many ways including heat I tried my air chisel with the small bullnose point bit. There is a slight dimple on the bottom of the pin that allows the bit to seat nicely then the air hammer action smoothly drives it out. It was nice that on the 120 they only has 2 instead of the 8 on the Fordor!
Posted on: 2022/1/6 19:27
|
|||
|
Re: 120C conv. hinge pin removal
|
||||
---|---|---|---|---|
Just can't stay away
![]() ![]() ![]() |
Ihave removed hinge pins by welding a small bolt an a C calmp and spacing the top with a nut. This enables you to put maximum pressure on the pin and apply heat if neccesary
Posted on: 2022/1/6 20:40
|
|||
|