spark plug wiring loom
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
My 51 has a rubber insert in the spark plug loom, above the coil. It is housed in two pieces of metal, like a box. My 39 120 only has the bottom half of the box, except on the 39 it is more wedged shaped. First question, is there supposed to be a rubber insert similar to the 51? And if so, any suggestions as to where to get one? This is all Steele Rubber shows:
http://www.steelerubber.com/spark-plug-wire-spacer-70-0394-21 Thanks
Posted on: 2014/8/31 18:43
|
|||
|
Re: spark plug wiring loom
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
According to parts, 39 used the same 4.1111 two piece metal wedge shaped item as used thru 47..Believe that is just a box like enclosure which surrounds neatly laid parallel wires -- Nothing is specifically called for that I can see but there may have been a layer of insulation like material separating the wires from the metal. It would have to be thin because there is just slightly more height than the wires inside the box. The 48-54 used a different cable holder and the rubber block.http://www.steelerubber.com/ignition-cable-grommet-70-1598-21
All models also used 4.1109 rubber items similar to the one you linked to in the area over the head to hold wires together and guide them toward the plugs. Believe Packards was a 3 and a 5 hole combination but since Steele doesn't have the 5, maybe a couple of 3's and that Cadillac 4 hole could be used.http://www.steelerubber.com/spark-plug-wire-spacer-30-0313-21
Posted on: 2014/8/31 19:37
|
|||
Howard
|
||||
|