Re: flywheel cover 1948
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
The heavy cast bottom completes the structural rigidity of the housing, and on overdrive equipped cars provides a place for the 5th trans bolt. If yours is bolted to the frame, something is wrong. The powerplant was mounted at one point in the front, and at both sides of the trans in rubber. Depending on the model and equipment there might be two more rubber auxiliary mounts near the front of the engine (Custom Eights), and a vertical rubber cylinder under the back of an overdrive.
Show us a picture of what you've got.
Posted on: 2015/10/24 21:05
|
|||
|
Re: flywheel cover 1948
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
The 5th bolt (bottom) is a real pain because one cannot remove the cover and inspect the clutch /throw out bearing without having to remove the rear transmission support.
Who came up with that idea!?!?!
Posted on: 2015/10/25 19:03
|
|||
Bill,
Dedicated to keeping the man who owns one on the road!!! |
||||
|
Re: flywheel cover 1948
|
||||
---|---|---|---|---|
Just popping in
![]() ![]() ![]() |
thanks for your replies, I will try to get a pic up asap.
It's in pieces, it wasn't on the car when I got it, so I don't know how it was, just know where it looks like it wants to go. I hope that makes sense.
Posted on: 2015/10/26 2:53
|
|||
|
Re: flywheel cover 1948
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
If you look at my video on youtube.comhttps://www.youtube.com/watch?v=vk_x2yp7F2k I show how I took off my Clutch Cover maybe that will help.
Wes
Posted on: 2015/10/26 6:23
|
|||
|