Re: Series 23 Bracket ID
|
||||
---|---|---|---|---|
Forum Ambassador
|
They look like they may be the pieces circled in red.
If not, see if they will fit between the inner edge of the rear flat splash panel over to the bottom of the fender somewhat along the path of the red line -- either in front or behind the flat panel. The 47 has a similar looking but longer piece behind the panel going over to a hole in the fender bottom edge.
Posted on: 2017/8/2 12:55
|
|||
Howard
|
||||
|
Re: Series 23 Bracket ID
|
||||
---|---|---|---|---|
Home away from home
|
It goes between the fender and the top of the rear splash panel and is actually shown in the parts list illustration but not labelled.
Posted on: 2017/8/2 13:00
|
|||
|
Re: Series 23 Bracket ID
|
||||
---|---|---|---|---|
Home away from home
|
Howard,
Too short for that area, but you got me looking closer at that plate. They were stored with my grille parts so I thought they went in the front. But looking closely at the picture you attached, I believe it is the piece to the upper left of the air duct hole in the splash panel. I was trying to fit it in the wrong area. It bolts to the splash panel and to the horizontal edge on the back of the fender. There are 2 holes in that area of the fender so I believe that's where it fits.. Thanks for your help! Joe
Posted on: 2017/8/2 13:16
|
|||
|
Re: Series 23 Bracket ID
|
||||
---|---|---|---|---|
Home away from home
|
BDeB,
Great picture, that what I was trying to say to Howard. Thanks. Joe
Posted on: 2017/8/2 13:18
|
|||
|