Packard Forum Index » Post-War (1946-54)

I can't seem to figure out how to remove the manual brake pedal assembly on my 200. If anyone can provide a little guidance I'd really appreciate it .

I've attached some photos as reference.

Thanks in advance!

Attach file:

---

  (249.45 KB)


  (412.58 KB)


  (64.47 KB)

Anyone?'

Jason,
My '47 is a different design, but if you haven't already, I would take a look at the Part Diagram Plate #63 in the Parts list on this site. Doesn't show very clearly, but might give you some clues until someone else chimes in. From the diagram, it looks to me that the zerk end should have a c-clip or something to hold that end in place. I see the parts list calls for 1.30655 "retaining ring".
Good luck,
Mark

In your third photo, there is a washer next to the pedal on the passenger side, then next to it a circular cup that holds everything in place.
Removal of the clip will allow the shaft to be moved towards the drivers side so that the pedal can be taken out.

thanks Gents, that made all the difference!