56 Executive Turn Signal Bulb Replacement
|
||||
---|---|---|---|---|
Home away from home
|
I need to replace the turn signal bulbs on a 56 Executive and don't want to crack the plastic lens. I can see two screws from the front grille area and a small nut on the inside of the fender. There must be another fastener that is not readily apparent to me. Can anyone help?
Posted on: 2010/9/13 21:47
|
|||
Bob
IF EVERYTHING IS COMING YOUR WAY ... - - - - - - - - - - - - - - - - - - - - - - - - YOU'RE IN THE WRONG LANE! '56 Executive Touring Sedan |
||||
|
Re: 56 Executive Turn Signal Bulb Replacement
|
||||
---|---|---|---|---|
Forum Ambassador
|
Since you mention grill, assume you mean parking light. The 3 screws mentioned hold the entire parking light assy to fender and grill. When those are out the assy can be removed and the actual lens is held to the assy by 5 screws. Be aware the plastic may be very brittle and if heat crazed, even removing the 5 screws may cause the molded screw hole area to separate. I don't know if any type of lube would help so be gentle & keep fingers crossed.
Posted on: 2010/9/13 22:23
|
|||
|
Re: 56 Executive Turn Signal Bulb Replacement
|
||||
---|---|---|---|---|
Home away from home
|
I didn't mention that it is the front parking/turn signal bulbs (my bad).
Posted on: 2010/9/13 22:23
|
|||
Bob
IF EVERYTHING IS COMING YOUR WAY ... - - - - - - - - - - - - - - - - - - - - - - - - YOU'RE IN THE WRONG LANE! '56 Executive Touring Sedan |
||||
|
Re: 56 Executive Turn Signal Bulb Replacement
|
||||
---|---|---|---|---|
Home away from home
|
Thanks for the info once again.
Posted on: 2010/9/13 22:44
|
|||
Bob
IF EVERYTHING IS COMING YOUR WAY ... - - - - - - - - - - - - - - - - - - - - - - - - YOU'RE IN THE WRONG LANE! '56 Executive Touring Sedan |
||||
|
Re: 56 Executive Turn Signal Bulb Replacement
|
||||
---|---|---|---|---|
Forum Ambassador
|
Here's the latest score folks;
Howard 1, Dummy 0 Howard is right about the screws holdings the lenses. You might try some PB Blaster just to allow some lubricant to work its way into the threads.
Posted on: 2010/9/13 23:02
|
|||
|