Packard Forum Index » V-8 (1955-56)

My vent window trailing edge rubber was shot and I should really install the new stuff. It is retained by very small & short pop rivets and I wonder if anyone knows what dimension these rivets might be? The squeezed length appears to be amount .2 inches.
Also on the door seals, the repro seals do not cover and seal the relief "notch" for the door strikers. (see photos) Can I assume that others have had this same problem?
The Packard boys surely were sharper than this.

Attach file:

---

  (134.01 KB)


  (151.67 KB)