Re: Senior Oil Pressure Sending Unit
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
There is a Napa sender I suspect might work since it was used on multitudes of Ford products and we do know the Ford gas tank sender works for us. There are no real specs on the unit given though.
If anyone is so inclined to possibly throw $ 13.69 (online price + shipping) down the proverbial fixture in the interest of experimentation and possible benefit to Packard mankind, here is the item. Probably available locally since there are 150+ common Ford products that use it. I copied a few of them for illustration. Having mentioned this as a possibility, understand I have not bought, tested, tried or otherwise even looked at the oil unit. Would hate to have someone spend money on my say-so only to find it won't work. Something from our vendors would be the safe choice.
Posted on: 2012/7/12 18:41
|
|||
Howard
|
||||
|
Re: Senior Oil Pressure Sending Unit
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Quote:
Thank you yet again Howard. I think I'll take you up on the Pressure Sender Challenge. I know what my engine is putting out thanks to the manual gauge so it will be pretty easy to see where the sending unit stacks up with reality. Plus, $13.69 is pretty reasonable and even if it doesn't work out, at least we all will know if it's an option. I'll call NAPA this morning and get back to everyone this evening or tomorrow at the latest. Thanks again Howard.
Posted on: 2012/7/14 10:54
|
|||
1951 200 Deluxe Touring Sedan
1951 200 Deluxe Touring Sedan (parts ?) 1951 Patrician Touring Sedan 1955 Patrician Touring Sedan |
||||
|
Re: Senior Oil Pressure Sending Unit
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Just looked up the part on the NAPA website and the sending unit is still available - AND guess what? The price has actually gone DOWN! It's listed at $12.63. At that price it as at least worth a try.
More later this weekend.
Posted on: 2012/7/14 11:21
|
|||
1951 200 Deluxe Touring Sedan
1951 200 Deluxe Touring Sedan (parts ?) 1951 Patrician Touring Sedan 1955 Patrician Touring Sedan |
||||
|
Re: Senior Oil Pressure Sending Unit
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Hey Gang,
Went and picked up the NAPA Oil Pressure Sending Unit mentioned by Howard and installed it yesterday. At first glance, the oil pressure gauge reads the same as the manual gauge it replaced so I think the Echlin (ECH OP6091) sender is a "go". It does appear to be a tad wider than the OEM but with care, it screws right down. As an added benefit, the threads are pre-treated with sealing media. The reason I said "at first glance" is that when I started the car up to check the function the hot water hose from the engine to the thermal valve ruptured delaying any further testing until I replace the hose this afternoon. All in all, the ECH OP6091 sender from NAPA seems to be a good alternative - especially for $13. I'll post a further test after the little heater hose problem has been righted. At least the hose waited until the car was safely in the driveway to let go. If the follow-up test goes well, I'll post the part number in the Packard Parts X-Ref section. Thank you again, Howard, for coming up with this number.
Posted on: 2012/7/16 15:00
|
|||
1951 200 Deluxe Touring Sedan
1951 200 Deluxe Touring Sedan (parts ?) 1951 Patrician Touring Sedan 1955 Patrician Touring Sedan |
||||
|
Re: Senior Oil Pressure Sending Unit
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Jim, never a dull moment with old cars is there. Like you said, at least it had class enough to do it in your driveway.
We'll keep our fingers crossed that the oil sender continues to check out well. If it does, then there may also be a Ford temp sender that will work with our gauges and be worth looking at.
Posted on: 2012/7/16 15:35
|
|||
Howard
|
||||
|
Re: Senior Oil Pressure Sending Unit
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Yesterday evening was devoted to replacing the engine to thermal valve hot water hose. Decided that the easiest method was to unbolt and lift the heater assembly out of the way. Getting the old hose off was no problem as it was so rotten that I'm amazed it lasted as long as it did. It was so swollen, that I had difficulty deciding what size hose to replace it with so I took the remains to the auto parts store where we decided that it was 3/4" stock. Had everything buttoned back up by sundown so just ran the engine long enough to see that there were no leaks.
Took her out for an extended drive this morning to check on the Oil Pressure Gauge readings with the new Echlin sending unit. Gauge ran consistently close to the manual gauge readings. The sending unit is set to measure pressure from 0 to 100 psi so 50 psi should have the dash gauge reading halfway which it does. As I mentioned earlier in some post or other; I'm using the car as a daily driver to shake down all systems so by the end of the week, I should be able to state whether or not we have a "winner". Thanks again Howard for suggesting I try this gauge. I was a little leary of it due to the $13 price tag but so far so good. It even looks like the OEM unit. More later
Posted on: 2012/7/17 15:18
|
|||
1951 200 Deluxe Touring Sedan
1951 200 Deluxe Touring Sedan (parts ?) 1951 Patrician Touring Sedan 1955 Patrician Touring Sedan |
||||
|