Re: T-L system stopped functioning
|
||||
---|---|---|---|---|
Just can't stay away
![]() ![]() ![]() |
I have power to the purple lead to 3 prong brake light. Nothing to the underdash switch when brake applied or not. Yet, when under car with test light, had daughter step on brake I had power at control box. Control box is the solid state from Max Merritt, that is where I also got the solenoids & a new underdash switch. The leveling seems to have quit working around the time I replaced the brake light switch. That would be about the same time the brake lights started working again??? I'm going to try a different new brake light switch to see if anything changes......
Posted on: 2013/8/17 15:04
|
|||
|
Re: T-L system stopped functioning
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
To totally bypass the brake switch, remove the plug and temporarily jumper the purple or pink wire to the light green wire. That should give you power at the control box as if the car was sitting or driving down the road. After that, you should be able to check out the entire TL circuit.
The new brake switch could be faulty or it could have the contact terminals in a different arrangement than the Packard switch.
Posted on: 2013/8/17 15:12
|
|||
Howard
|
||||
|
Re: T-L system stopped functioning
|
||||
---|---|---|---|---|
Just can't stay away
![]() ![]() ![]() |
Success!! I got another nos brake light switch from stash, installed it & the torsion leveler WORKS!!!
Brake lights too. THANK YOU FOR YOUR HELP!! ![]()
Posted on: 2013/8/17 15:56
|
|||
|