Re: ultramatic direct drive clutch wont release until hot
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
i did have the dd not disengage ,,, i was screwing around with the throttle rod on the engine, had it out of wack. the cross shaft and the throttle and the carb linkage, had it out of wack,,
when it was put back like it was supposed to be, worked fine,
Posted on: 2013/11/10 23:42
|
|||
Riki
|
||||
|
Re: ultramatic direct drive clutch wont release until hot
|
||||
---|---|---|---|---|
Just popping in
![]() ![]() ![]() |
Thanks Peter and Riki for your help i agree about valve body and TV linkage adjustment. The owner has given permission to purchase another if needed. i adjusted linkage per book and then changed from there with inconsistant results I have figured out that the two front converter bushings and reaction shaft bushings are blocking apply and release passages by mocking up parts and dying input shaft to see where bushings are in relation to passages. This only happens if input shaft runs in full forward position. a light wear pattern at bottom of converter snout suggests that it does. To me this would explain release when hot as clearances increase and fluid thins. adjusted bushing position to compensate for full forward movement of input shaft.dont know that this is the problem but now can eliminate as a possibility if it happens again .
Posted on: 2013/11/11 11:34
|
|||
|
Re: ultramatic direct drive clutch wont release until hot
|
||||
---|---|---|---|---|
Just popping in
![]() ![]() ![]() |
(PRAISE THE LORD) Its fixed just wanted to let everyone know trans is working great now TCC is unlocking now and shifts are spot on. The problem was of my own doing.Something I should have not been able to do I did by mistake. I had the governor and parking gear misalighned with the planetary ring gear shaft. The little pin between the splines of the shaft that indexes the gov assembly with the wide grove of the gov parking gear splines was worn down this alowed assembly in any position and restricted fluid flow to and from governor.Just by luck I had it one spline off alowing it to work but not right. I Thank all of you for your help, maybe this info will help somebody thats having similar problems after a rebuild.
Posted on: 2013/11/15 16:36
|
|||
|
Re: ultramatic direct drive clutch wont release until hot
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Glad you found the problem and resolved it. And thank you for posting your mistake so others could watch for it and not make same error.
![]()
Posted on: 2013/11/15 18:02
|
|||
|