Re: how do we wire a deluxe 1940 heater /defroster with 4 wires?
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
O'Boy, always read twice before you submit.
Next time i will use spell check and then read twice to be sure.. John miller
Posted on: 2015/1/8 22:27
|
|||
|
Re: how do we wire a deluxe 1940 heater /defroster with 4 wires?
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Unless someone can come up with authentic Packard accessory install diagrams, here is one possibility. Take it for what it's worth but this is what I came up with and BELIEVE to be correct. There may be more than one version though. If your wires are in better condition it would be good to know if this is right.
As you can see from the before photo the original wiring on this motor had all faded to about the same color so it was hard to tell with absolute certainty where the wire colors (except for green) went in the motor. Based on a prewar Clipper schematic, some labels on a Clipper switch and on how the motor has to work, this is what I believe correct. After replacing the wiring on this motor and going with the color arrangement chosen, it appears to work as intended. The motor has two speeds (the round sw is missing a resistance coil for one direction) and it reverses with either the Packard round switch or the Clipper push/pull switch. The only caveat would be the rotation might not be correct for the functions or switch labels on the nameplate so worst case with this arrangement the red and brown wires would need to be reversed on the switch. Here are photos showing the current path in the round switch along with a schematic. The white bars designate the contacts which move across the terminals as the switch is turned to complete the circuit and place the armature and field in series. Basically the Bat voltage is applied to the switch and goes to armature via the red or brown wire depending on direction, out to motor and comes back into switch via the opposite red or brown and then goes back out via the yellow wire to the motor field and then to ground via green wire. If you don't have a Packard switch the heat/defrost reversal function can be duplicated with a DPDT center off toggle switch but there would be no low speed. Have included a drawing showing how that can be done using this color combination. You could also use a universal heater on/off switch with rheostat for the variable speed to feed the toggle switch and change the center off DPDT to a two position DPDT for the heat/defrost function
Posted on: 2015/1/9 15:49
|
|||
Howard
|
||||
|
Re: how do we wire a deluxe 1940 heater /defroster with 4 wires?
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Since the time of the original 12 PM post I discovered I had made a transposition error on wire colors in the schematic. That has been corrected so if anyone wanted the info and saved one of those first drawings before this 8PM post please save it again.
Posted on: 2015/1/9 23:35
|
|||
Howard
|
||||
|
Re: how do we wire a deluxe 1940 heater /defroster with 4 wires?
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Howard, Thank you. Pulling the heater today and will have the motor rebuilt with the wiring to the schematic you provided.
As usual "Packard Information members prove to be a valued reasource" thanks again John Miller
Posted on: 2015/1/10 11:51
|
|||
|