Re: 47 Steering Column disassembly help needed.
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Wesley Boyer. Cordova Tennessee. Is that in Memphis area??
Memphis is all that will show on Google maps. I'm 30 miles WEST of Nashville Tn.
Posted on: 2016/10/6 14:26
|
|||
VAPOR LOCK demystified: See paragraph SEVEN of PMCC documentaion as listed in post #11 of the following thread:f
https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?topic_id=7245 |
||||
|
Re: 47 Steering Column disassembly help needed.
|
||||
---|---|---|---|---|
Quite a regular
![]() ![]() ![]() |
Too bad I did not take pictures.
The sleeve is hardened steel and has an outer diameter of 25 millimeters at a length of 17 millimeters where the needle cage fits. Then there is a short section with a bigger diameter of about 30 millimeters as a stop for the needle cage. The sleeve is a light shrink fit on the shaft with the bigger diameter section downwards/forward, under the needle cage to stop it from sliding down the steering shaft. The needle cage moves freely up and down in the outer race. To remove the outer tube I just release it by the steering gearbox and lift, the outer race stays with the tube and the needle cage stays on the sleeve by gravity but it can be removed just by lifting off. When the body comes in place of course the tube most also be freed from the instrument board before removal. The tension spring is not installed as there is no need for any axial force on the bearing but I may install it later with a plain washer instead of the concave ring just to make it look original when the steering wheel is removed.
Posted on: 2016/10/7 1:29
|
|||
|
Re: 47 Steering Column disassembly help needed.
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Very nice. That seems like a viable alternative for anyone missing parts of the original bearing and unable to find the needed pieces. The replacement bearing seems to be easily available from several places but I don't know how easy or expensive it would be to have the sleeve machined.
As to the spring, I don't think anyone would know or even miss the tension spring if it was not present. As you said, it no longer serves a purpose and if the sleeve is a light fit on the shaft could tend to push the bearing assy and sleeve down the shaft a bit farther. In that case the spring probably wouldn't do much anyway. About the only reason to have it would be to keep it available in case at some point someone found or repaired an original and wanted to go back to stock.
Posted on: 2016/10/7 10:30
|
|||
Howard
|
||||
|
Re: 47 Steering Column disassembly help needed.
|
||||
---|---|---|---|---|
Quite a regular
![]() ![]() ![]() |
Totally agree with all You said.
I just do not like loose bearing balls but in the future if somebody wants to have it the way it was from the beginning it would be handy to find the spring. ![]() ![]()
Posted on: 2016/10/7 15:15
|
|||
|