Packard Forum Index » Post-War (1946-54)

On both, my parts books and this websites parts listing, I am unable (nothing unusual) to come up with parts listing for the belt molding that is under the two rear quarter windows on a 1954 two door hardtop PACIFIC.I need these numbers in order to try to purchase them from some vendor.

I believe those pieces under the quarter windows continue around under the rear glass and are called the lower moldings. The same pieces were on all hardtops, the Pacific being the 5477. Believe the short curved pieces around the front side and center of the rear glass are the upper moldings. If that is correct, then I believe these will be the part numbers needed. Kanter might have NOS and other vendors might have some used.

Attach file:

---

  (130.52 KB)

Most vendors including us do not require part numbers to place an order. Just like your local Chevy dealer, you can walk in and ask for a left front frammis port.

Howard, I am truly thankful for your answer to my problem. The key word to my whole problem was continues,(its been two years since we took off all the moldings), I surmised it to be a separate stand alone molding which it is not. I had even called Kanter and described it to be a small section of about 21 inches.
I have both the driver and passenger side in the shop, now I have to figure out what I'm planning to do with the money you saved me. Thanks again Carl