Re: 1956 Torsion-Level gearbox
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
I believe it will only go within a very narrow range because inserting the retaining bolts requires they have a fairly straight path into the top half to fit thru the holes. Believe the one next to the limit switch (arrow) in the illustration is offset outward from the circle pattern of the others and can only fit in the one place. That would serve as a locating point. I didn't measure but looks like there is slightly wider spacing between the pair of bolts on either side of the limit switch on the opposite side.
When I assembled mine the only thing I worried about was to have the "Vee" or bottom point of the lever facing the passenger side as the birds eye view photo shows. Since the cam plate is keyed to the lever it will then be in the correct position in the bottom housing too.
Posted on: 2017/4/11 13:09
|
|||
Howard
|
||||
|
Re: 1956 Torsion-Level gearbox
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Quite correct Howard. As long as you have the 'V' facing the passenger side, it is aligned properly because the gear that engages the 'V' has a blind spot as shown in the pics. The shaft can only enter the gear one way and if you align the 'V' properly everything is aligned properly. I should have guessed Packard wouldn't leave something so critical to chance.
Posted on: 2017/4/11 13:30
|
|||
|
Re: 1956 Torsion-Level gearbox
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
The T-L gearbox (55 or 56) looks complicated, but it's not as difficult reassembly as it might seem. Here's what I did on my 56 Panther (nee Clipper). I also overhauled the gearbox in my 55 Pat soon after. Both had problems, but are now good to go.
http://1956packardpanther.com/Panther/torsionbars5.html Craig
Posted on: 2017/4/11 16:29
|
|||
Nuke them from orbit, it's the only way to be sure! Ellen Ripley "Aliens"
Time flies like an arrow. Frui |
||||
|