Re: Paint Question--1956 Patrician
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Just my two cents but getting a paint match depends a lot on the guy doing it -- both in making the color and applying the paint. The spectro is supposed to be spot on color wise but I haven't had any of the fancy machine matches done. Have had several matches done by eye and some of the guys are quite accomplished. A wannabe but not quite authentic shade of Packard blue on my 47 was perfectly matched in enamel by one of the local stores.
At any rate just painting a trunk lid is liable to lead to disappointment. Fortunately there is a seam all around to break new vs old but the fact you have a large surface of new color surrounded by old on 4 sides is inviting any mismatch to show. Add that to the possible fading and it becomes more of a challenge. You might be able to get an idea if there is any fading and how much by removing the trunk emblem Vee and circle to see if there is any original unfaded paint under the pieces. Take the gas filler lid which one would assume to be faded the same amount as the car and have new paint matched to that. I would think that is about the closest match you will be able to get assuming the paint is not metallic. Several have had issues trying to match the metallic flake size and composition between old paint and what is available today. Not sure what kind of restrictions there might be on paint in your state due to volatility etc but some states (Calif is one) will leave you very little choice in what type paint you can buy. The different paint types is another guaranteed route to a visible mismatch.
Posted on: 2018/6/21 18:50
|
|||
Howard
|
||||
|
Re: Paint Question--1956 Patrician
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Spectrophotometers are not meant to be used with special effect paints. The light is reflected at an angle and metallic flake scatters it. The error is less with fine metallics, but still an issue. Also need to watch for metamerism, changes in match under different viewing conditions. Find a place with a good color matcher and use a visual standard. Keep in mind that the rest of your car is weathered from original, so you are trying to match that, not the original color
Posted on: 2018/6/22 8:09
|
|||
|
Re: Paint Question--1956 Patrician
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
You can try an outfit in Rockaway NJ called Hibernia Auto Restoration. They mix nitrocellulose in small quantities. I have personally used them on a 62 Vette that need one panel that needed to be resprayed. I had purchased a qt.
Thanks James From Kanter Auto Products
Posted on: 2018/6/22 9:27
|
|||
|
Re: Paint Question--1956 Patrician
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
I would endorse Hibernia also. When I had Best Other painted they supplied the lacquer. Good company - very helpful.
Posted on: 2018/6/22 12:21
|
|||
|