Packard Forum Index » Project Blogs

Tinman
Here's a photo. I can take a few more if you would like.
dp

Attach file:

---

  (102.95 KB)

While waiting for my AC compressor to arrive, I decided to install the Newport electric wiper motor. If you decide to replace the Trico vacuum motor on your Packard with one of these, don't expect it to bolt right on as advertised. Took some grinding and drilling on their mounting bracket to get it to fit correctly. I doubt that they actually tried to mount one a Packard! Finally got it on but took much longer that I expected.

Attach file:

---

  (105.84 KB)

I have to say that after the difficulty getting this to fit on my Packard, once on and wired it works perfectly.

Finished the AC compressor mount. Plate on plate to allow adjustment. Need to finish the welding. Got the new longer belt with my "belt measuring device" and the help from NAPA.

Attach file:

---

  (79.52 KB)


  (103.87 KB)


  (84.61 KB)

Now that the compressor is firmly in place, I'm starting to mock-up the hoses. There is a bulkhead fitting plate mounted on the plate covering the hole left when the original heater was removed. The bulkhead fittings connect the hoses from under the hood to those in the evaporator unit under the dash. The 2 fitting on the top are for refrigerant lines and the ones on the bottom are for the heater hoses. I have a bunch of fittings left from other AC projects, they should help with the mock-up of the new hoses.

Tinman

Attach file:

---

  (88.12 KB)


  (98.29 KB)

Finally received all the fittings to make up the refrigerant and heater hoses. Due to lack of room beside the radiator, going to have bend hard lines to get from the condenser connected to the compressor and evaporator unit. Would have been much easier with the car dis-assembled!

Attach file:

---

  (96.21 KB)


  (103.39 KB)


  (84.16 KB)

Got the hydraulic hose crimper and are ready to start making the the refrigerant and heater hoses.

Attach file:

---

  (106.37 KB)

Finished mocking-up the AC and heater hoses under the dash, very tight fit.

Attach file:

---

  (91.18 KB)

All the AC and heater hoses have been made-up and crimped. All the components have been capped to prevent excess moisture while the system is dis-assembled. The compressor is being removed and the welding of the mounting bracket completed.

Attach file:

---

  (81.74 KB)

Got all the AC mounting hardware painted and installed the compressor for the final time. Fan belt was installed and tensioned. Next will be the final installation of the electric fan and condenser assembly and adding the AC and heater hoses.

Attach file:

---

  (103.80 KB)