20210909_113754.jpg (417.80 KB)
|
Re: ISO 1937 120-c water pump back plate
|
||||
|---|---|---|---|---|
|
Forum Ambassador
 
|
Not aware of a reproduction but that plate looks entirely serviceable. Dress the surface a bit if you wish with some emery cloth on a flat backing, but even as is just a normal gasketing job with Permatex or gasket shellac should be all that's required.
But I do notice a witness mark where the center of the impeller has contacted the plate and that warrants some investigation.
Posted on: 2021/9/9 16:59
|
|||
|
||||
|
Re: ISO 1937 120-c water pump back plate
|
||||
|---|---|---|---|---|
|
Home away from home
 
|
Thanks Owen, I'll try a little Emery cloth just to clean up a little bit. I had used some permatex before and had a small leak, hence my concern. Yeah I noticed that mark as well. I'll investigate.
Quote:
Posted on: 2021/9/9 23:02
|
|||
|
||||
|
Re: ISO 1937 120-c water pump back plate
|
||||
|---|---|---|---|---|
|
Home away from home
|
I have a backing plate. Contact me at 210-260-5646 email at will@rpland.com. Visit my website for other parts at rpland.com/packardparts
Posted on: 2021/9/10 1:48
|
|||
|
||||
