Re: 733 brakes locking on
|
||||
---|---|---|---|---|
Not too shy to talk
|
Thanks Jim Wayman
The info. is greatly appreciated and matches my description. I'm missing the brass cover on both sides. The smaller cups with the flange,springs and retainer clips are ok. When I take the clip and spring out, the hole in the flange of the cover seems to be to small to come back over the flange of the shaft. That's what I'm confused about.I'm thinking the dust covers,spring and clip should all slide back towards the frame off the shaft, then the rest of the unit can slide out of the Perrot housing towards the drake drum , then the pin could be removed and the unit disassembled. Am I explaining this ok, it sounds a little confusion? Thank Ed
Posted on: 2010/6/28 13:08
|
|||
|
Re: 733 brakes locking on
|
||||
---|---|---|---|---|
Home away from home
|
Here is a rough drawing of the shaft and small cup. The cup should come off toward the center of the car.
Jim Wayman 640 Phaeton
Posted on: 2010/6/28 14:30
|
|||
|
Re: 733 brakes locking on
|
||||
---|---|---|---|---|
Home away from home
|
Picture did not attach. Had to change from a tif to a pdf.
Jim Wayman 640 Phaeton
Posted on: 2010/6/28 14:36
|
|||
|
Re: 733 brakes locking on
|
||||
---|---|---|---|---|
Not too shy to talk
|
Thanks Dave
I copied all the information you send and I'll study it over the next few days.Just looking at it quickly it does'nt seem to match mine,it looks like there is a grease cap? Again thanks for the info. ED
Posted on: 2010/6/28 14:41
|
|||
|
Re: 733 brakes locking on
|
||||
---|---|---|---|---|
Not too shy to talk
|
Good picture Jim
Mine looks the same ,except I think some how the spring seat has gotten bend, slipped in behind the flange of the shaft and can't slide back now. Now that I see your picture I know what I have to do , just was'nt sure. First I'm going to put the body back on the chassis and see if that corrects my problem, as there does'nt seem to be much wear on the Perrot unit. I'm hoping the wieght of the body will line things up. I'll let you all know how I make out, but it will be a while. Thanks very much Ed
Posted on: 2010/6/28 15:22
|
|||
|