Re: hph's 55 Clipper Project
|
||||
---|---|---|---|---|
Home away from home
|
How is this supposed to look / be attached normally?
The vinyl kick panel.
Posted on: 6/12 18:06
|
|||
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog 1955 Clipper Super Panama | Registry |
||||
|
Re: hph's 55 Clipper Project
|
||||
---|---|---|---|---|
Home away from home
|
Ok reference photo here.
Attach file: 17595740.jpg (65.65 KB)
Posted on: 6/12 18:37
|
|||
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog 1955 Clipper Super Panama | Registry |
||||
|
Re: hph's 55 Clipper Project
|
||||
---|---|---|---|---|
Home away from home
|
I pulled the engine and transmission out of my Clipper last weekend. Not too wild but getting the oil pan to clear without the trans bell housing being forced against the body was a bit of a trick. Also the propeller shaft flange gets caught on its support, though I had jacked it up so the studs would clear. In the future I think I will remove that single bolt holding it on. Though I'm not sure that would actually help on install. Might remove both that and the studs.
This engine and trans is going to a guy who plans to rebuild the both and swap out his tired 352. So he can be back on the road in a week
Posted on: 6/18 9:19
|
|||
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog 1955 Clipper Super Panama | Registry |
||||
|
Re: hph's 55 Clipper Project
|
||||
---|---|---|---|---|
Home away from home
|
I installed a new radiator in my car last weekend. I explained it in depth, with instructions, here:
https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?topic_id=5042
Posted on: 6/27 21:22
|
|||
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog 1955 Clipper Super Panama | Registry |
||||
|