Packard Forum Index » Pre-War (1899-1942)

We are at the point of attaching the transmission to the engine.
Unfortunately, there are seven pins holding the springs in place. Those pins go into holes in the flywheel.

The shop manual gives very detailed instructions on separating the transmission from the engine.
For the installation, it simply states:

Reassemble in reverse order of removal."

Certainly someone out there in Packard world has crossed that bridge.
Any advice on lining up the pins would be appreciated.

Bob

Attach file:

---

  326springpin.jpg (59.01 KB)


  326pin holes.jpg (41.49 KB)