Try these guys for visors

http://www.skirtsandvisors.com/

Get a 6volt electic fuel pump-I think one of the packard clubs are selling them for about 75-I think!!

If you have not already checked WWW.packardclub.org-it gives production numbers of various models. As far as parts-Kanter, Max Merritt, etc sell basically everything. I would try and get a copy of Hemmings Mag. All these have web sites as well. Hemmings will give you sources for all most anything. Ebay also is a good source for parts.

The car as you probably know is a very desirable Packard especially with its history.

Who is/was selling the red center sections-I thought it was a Packardclub item but could not find it

Will the 288 starter mtr fit a 356 engine?

Will the 288 starter mtr fit a 356 engine?

It is worth probably a couple of hundred $. Then you have the transportation issue which is not cheap either.

If you are referring to a rubber like seal in the"notch" in the hood next to windshield-my 47 has it.

Thanks Kev-I knew I had seen that stuff at a car show!! I guess I should not use it based on the replies

I think wheel bearings are roller type vs a ball type bearing-309 is not that big of a bearing. Probable uses are in the transmission or rear axle.