hh i think i have one, but it is in pieces, i know i took apart a btv and the rod had that seal at end,,,think it was off a 56 clipper we had,

something a miss,, i have composition too, from mr gasket, they line up,

hh, yes i made bushings from flexane 80,,from molds my dad made, he made molds for round and the 55 sorta rectangle ones which i use on bottom,

they are still holding ,,only sitting, since engine is in i guess i should see how it works, but need road miles ,,,

i can make only one each, so it takes awhile to get a set, done,

might get parts from chrysler,,,,think this came with my dads car,,don't spin test rear ,,

Attach file:

---

Size: 205.13 KB; Hits: 60

  (10.19 KB)

may 31,2014 engine in,

rear of engine supported bt 3/4 wood across frame, till trans is in,

Attach file:

---

  (78.72 KB)


  (75.19 KB)


  (86.03 KB)

56 block,, ready to lower in

that is kanter engine paint from the 80s, had to thin it out


NOS push Rods from Steves packard,,

Attach file:

---

  (105.27 KB)


  (106.76 KB)


  (109.38 KB)


  (66.50 KB)

If need be can make the nut

chips,,rocker shaft

Attach file:

---

  (63.33 KB)


  (63.33 KB)


  (89.09 KB)

oops,,gone

For anyone who fogets, like me,

Attach file:

---

  (89.09 KB)