|
Packard Twelve Rocker Lever Wedges
|
||||
|---|---|---|---|---|
|
Not too shy to talk
 
|
Packard manual references using tool ST-879 to hold the rocker back to set clearance on the valve stem length.
What has been used by others? Eric
Posted on: 4/5 10:40
|
|||
|
||||
|
Re: Parting out 55 400
|
||||
|---|---|---|---|---|
|
Not too shy to talk
|
Sold as a pair
Posted on: 2/1 18:56
|
|||
|
||||
|
Re: Parting out 55 400
|
||||
|---|---|---|---|---|
|
Not too shy to talk
|
I was told all SMS material and the bill was over $5k
Posted on: 1/27 21:40
|
|||
|
||||
|
Re: Parting out 55 400
|
||||
|---|---|---|---|---|
|
Not too shy to talk
|
Seats and panels.....
Attach file:  723510647.jpg (128.89 KB)
Posted on: 1/27 11:58
|
|||
|
||||
|
Selling 2 55 400
|
||||
|---|---|---|---|---|
|
Not too shy to talk
|
Decided to change direction, will sell both cars as a package.
Black one is currently licensed (the black plates are original to the car), has NEW seats, door panels and rear panels that never installed. Engine turns over. Pink one has no title Sell all for $6000 Eric voigt2106@sbcglobal.net Located in Riverside CA
Posted on: 1/26 17:45
|
|||
|
||||
|
WTB - 21", 6 lug-bolt disc wheel for 3rd Series Packard 8
|
||||
|---|---|---|---|---|
|
Not too shy to talk
|
looking for a single, restorable, 6 lug bolt, 21" disc wheel (w/lock rim) to fit my Packard 336. same as 2nd series 8. wears a 7.00 x 21 tire.
any clues or leads? Eric voigt2106@sbcglobal.net
Posted on: 1/7 20:59
|
|||
|
||||
|
Re: Parting out 55 400
|
||||
|---|---|---|---|---|
|
Not too shy to talk
|
To answer the questions -
- The pillar emblems are gone - Skirts are in the trunk - Roof is rusted through above the left topside - Floor is rusted out on the rear passenger side I had to take both the pink one to get the black 55 which came with 3 Caribbean wires and complete NEW interior that was never installed and stored in the owner's living room. Attached are photos that were requested. Eric Attach file: IMG_4301.jpg (29.30 KB) IMG_4302.jpg (36.17 KB) IMG_4303.jpg (22.96 KB) IMG_4304.jpg (23.62 KB) IMG_4305.jpg (21.12 KB) IMG_4306.jpg (17.78 KB) IMG_4307.jpg (15.54 KB) IMG_4308.jpg (15.63 KB) IMG_4309.jpg (18.42 KB) IMG_4310.jpg (16.69 KB) IMG_4311.jpg (105.09 KB) IMG_4312.jpg (99.02 KB)
Posted on: 12/21 12:00
|
|||
|
||||
|
Parting out 55 400
|
||||
|---|---|---|---|---|
|
Not too shy to talk
|
It appears complete, has engine and transmission, good doors and fenders and a like. No title
Roof is rusted as is the right rear floor. I'm keeping the rolling frame and some trim pieces. Located in Riverside Ca. Eric 951-315-1168 voigt2106@sbcglobal.net Attach file: IMG_4277.jpg (156.42 KB) IMG_4278.jpg (191.07 KB)
Posted on: 12/20 12:43
|
|||
|
||||
|
WTB - 2 Caribbean Wire Wheels
|
||||
|---|---|---|---|---|
|
Not too shy to talk
|
I need 2 original wires for my 55 Packard.
Do not want the reproductions. Any out there? Eric
Posted on: 12/6 19:45
|
|||
|
||||
|
WTB - 34 Super Eight Cylinder Head
|
||||
|---|---|---|---|---|
|
Not too shy to talk
|
ISO of the subject head, prefer the High Compression head but, will take the low compression cast iron as the current head is cracked and beyond repair.
Thank you, Eric voigt2106@sbcglobal.net
Posted on: 2023/10/14 15:20
|
|||
|
||||
