Fuel sending unit wire
|
||||
---|---|---|---|---|
Just can't stay away
|
Just had my fuel sending unit rebuilt.I need to replace the wire from it to the wiring harness. What gauge wire should I use? This is for my 51/200/288.
Posted on: 2014/3/1 6:07
|
|||
|
The 44th Annual Devereaux-Kaiser Collector Car Meet
|
||||
---|---|---|---|---|
Just can't stay away
|
While this is not a official Packard Car Show Tom Kaiser President/Founder of the Florida Packard Car Club puts on the show along with Devereaux. There are over 2000 cars and over 18,000 spectators will converge on Venice Florida Airport Fairgrounds at 8:30 this Sunday the 27th of January for a free show.
This one heck of a show. Cars of every make and model are pulled out of the garage just for this show. It is hard to believe that so many Cars are in the area.
Posted on: 2013/1/25 5:40
|
|||
|
Re: Transmission fluild
|
||||
---|---|---|---|---|
Just can't stay away
|
Update on my transmission:Dropped the transmossion and popped the top.Turns out I had a lot of teeth damage. Had to get a new cluster gear and second gear on the top was damaged . Replaced those and all the seals along with the sycro rings. Put it back together putting 90 weight oil in. Now it shifts and sounds better. While it was down I replaced the wiring harness from the dash to the rear tail lights. It is so nice to have my Car back.
Happy New Year Everyone. Happy Motoring.
Posted on: 2012/12/31 14:18
|
|||
|
Re: Transmission fluild
|
||||
---|---|---|---|---|
Just can't stay away
|
Ok. So I took off the top of the gear box on the transmission and looked down inside and seen the 2gear has some cracked teeth. Would anyone have a line on where I might be able to pick-up a cluster gear for a 3 speed manual trans.?
Posted on: 2012/10/13 15:11
|
|||
|
Re: Transmission fluild
|
||||
---|---|---|---|---|
Just can't stay away
|
Ok. So I found out today its not a fluid problem . It is my main shaft and bearing. It can never be something simple. So if anyone knows of a good 3 speed transmission laying around for sale please let me know.
Posted on: 2012/10/3 13:38
|
|||
|
Re: Transmission fluild
|
||||
---|---|---|---|---|
Just can't stay away
|
O Crap.
Posted on: 2012/9/30 10:30
|
|||
|
Re: Transmission fluild
|
||||
---|---|---|---|---|
Just can't stay away
|
Ok. So I finally got around to getting some fluid into the transmission. Didn't help. When I push the clutch in the bagging stops. When I let te clutch out and bring up the rpms its not as noticable. When I take it around the block its not as bad as it use to be till I put it in 2 gear then I have to get into 3rd fast to stop the banging. Thoughts?And does anyone know a good Transmission shop in Fl.
Posted on: 2012/9/30 7:53
|
|||
|
Re: Transmission fluild
|
||||
---|---|---|---|---|
Just can't stay away
|
Thank you very much for you reply. I am headn ou the door as I type this. Thanks again.
Posted on: 2012/9/16 10:42
|
|||
|
Transmission fluild
|
||||
---|---|---|---|---|
Just can't stay away
|
I need to add fluid to the transmission on my 51, 200. The book says Type A. Went to the Auto Parts store all kinds there,No Type A. Looked the X- Ref. No mention there. Any thoughts ?
Posted on: 2012/9/16 10:18
|
|||
|