Re: 1939 Heater pipe
|
||||
---|---|---|---|---|
Home away from home
|
You could mock up the pipe with some stiff wire. This is an easy way to get the bends and length, and then transfer them to the pipe. I wonder how easy the SS pipe will be to bend. My experience is the SS tubing is more stiff than its steel counterpart. The brackets should also be an easy fabrication once you get the pipe done. Just figure out how far the pipe needs to be from the head. Good luck.
(o[]o)
Posted on: 2017/2/18 11:21
|
|||
We move toward
And make happen What occupies our mind... (W. Scherer) |
||||
|
Re: 1939 Heater pipe
|
||||
---|---|---|---|---|
Home away from home
|
Actually just a side shot picture of the motor showing where the pipe ends up at the curve sections would do. More accurate than the wire method.
Posted on: 2017/2/18 14:20
|
|||
|
Re: 1939 Heater pipe
|
||||
---|---|---|---|---|
Home away from home
|
I finally found one! (That was clear of course!)
Posted on: 2017/2/23 0:20
|
|||
|
Re: 1939 Heater pipe
|
||||
---|---|---|---|---|
Forum Ambassador
|
Congratulations. Did you find a pipe or a photo? At any rate since information and the pipe is so elusive maybe you could post all the dimensions and shapes in case anyone else is in your situation.
Posted on: 2017/2/23 9:27
|
|||
Howard
|
||||
|