Packard Forum Index » Post-War (1946-54)

Does anyone know off hand what the two bolt holes in the dampener are? Thread and bolt size on a 1951 Packard 288 engine?

Thanks John

On 51 size is a question. The holes were for the damper puller. With 52-4 they were used for the puller as well as for bolts to attach the power steering pulley. I doubt there were new bolts for the pullers when 52-4 dampers came out and on those dampers the bolt size was 7/16-20. You might see if that size fits the 51 also.

Attach file:

---

  (85.38 KB)


  (62.04 KB)

Thanks HH56

No one would happen to know the center to center distance on the bolts?
Thanks John