Re: Rod Bearing Clearance
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
New bearing cap nuts not required, the originals are intended for re-use. I think the specification for rod end play is 0.003" to 0.011" but you can check for yourself, it's in the Packard engine specifications.
By individually shorting out the spark plugs one at a time, were you able to isolate the noise to a particular cylinder?
Posted on: 2018/11/18 9:08
|
|||
|
Re: Rod Bearing Clearance
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Shorting the plugs had no effect on the sound at all, other than dropping the idle a bit. But the sound remained in terms of volume and intensity as I went down the line individually.
Posted on: 2018/11/18 15:09
|
|||
1941 Touring Sedan
1952 250 Convertible 1932 902 Rumble seat Coupe ![]() |
||||
|