Re: '49 Pulls Hard When Braking
|
||||
---|---|---|---|---|
Home away from home
|
It could be collapsing hoses or even a leaky cylinder getting fluid on the shoes and maybe both. Either way it should be a relatively easy and inexpensive fix.
Collapsed hoses caused my 1985 Plymouth Voyager's nearly new (mileage-wise) brakes to virtually burn up (blued front rotors and rear drums) so brings to the forefront the need to flush brakes annually. It makes no difference how often the vehicle is driven either but replacing all rubber components (and the brake light switch), thoroughly flushing, then using synthetic fluid will greatly prolong life and minimize rubber deteriorization.
Posted on: 2019/5/4 23:31
|
|||
|
Re: '49 Pulls Hard When Braking
|
||||
---|---|---|---|---|
Home away from home
|
With the braking system thoroughly checked and no problem found, I would next check the kingpins. The 1937 120 I owned developed a pretty severe pull when braking that was usually to the left, just sometimes to the right. It turned out to be worn kingpins.
Posted on: 2019/5/5 21:31
|
|||
Don Shields
1933 Eight Model 1002 Seven Passenger Sedan 1954 Convertible |
||||
|