Re: Basic U joint 101 dumb question.
|
||||
---|---|---|---|---|
Home away from home
|
Here are some photos of the arrows on 2 different drive shafts. One is on the same side as the grease fitting and the other is opposite.
The arrow on the driveshaft lines up with the yoke on the far end that has the pressed in u-joint. The yoke on the slip joint with the pressed in u-joint should line up with the same one on the other end and will do so when the arrows match.
Posted on: 2014/5/5 12:27
|
|||
|
Re: Basic U joint 101 dumb question.
|
||||
---|---|---|---|---|
Forum Ambassador
|
Thanks. No luck finding the arrow. It appears it is covered with the worst of the rust pits so will go with lining up the round pressed in bearing caps.
Posted on: 2014/5/5 13:18
|
|||
Howard
|
||||
|